Does anyone here have any experience with the above mentioned scope mounts for their Contender or any other firearm for that matter? I'd like to known what you all think of them - good or bad?
-
Whether you're a greenhorn or a seasoned veteran, your collection's next piece is at Bass Pro Shops. Shop Now.
Vermonstah
I use/have the DNZ mounts on all of my CF rifles but one, no complaints at all, good quality/value for my use which is varmint rifles (pdogs & rats). I am considering changing the oddball rifle over to DNZ to raise the scope up a bit for this old neck of mine.
I really like the DNZ mounts. I have them on a 10/22 and a couple of CF rifles. I haven't used one on my Contenders because it only comes in one height. Shouldn't matter on a pistol but on a carbine it could.
Thanks for all the positive posts, I'd never heard of them till I bought a rifle on RFC Marketplace (should be here soon 
) that has a DNZ mount. I googled them & noticed they offer a mount for Contenders hence my question. After reading your replies I'm sure I'll like them & as soon as my rifle arrives & I see it 1st hand I'm sure I'll order one for my TC.I might need to get one for the rifle that's coming too as it currently has a Simmons 3-9x40 scope & I"m going to be mounting a scope with a 50mm objective lens so I might need taller rings. If I do I'm pretty sure I'll go with a DNZ . I really like the idea of a one piece mount
) that has a DNZ mount. I googled them & noticed they offer a mount for Contenders hence my question. After reading your replies I'm sure I'll like them & as soon as my rifle arrives & I see it 1st hand I'm sure I'll order one for my TC.I might need to get one for the rifle that's coming too as it currently has a Simmons 3-9x40 scope & I"m going to be mounting a scope with a 50mm objective lens so I might need taller rings. If I do I'm pretty sure I'll go with a DNZ . I really like the idea of a one piece mount
After I just got the 10/22 I bought from a fellow RFC member & saw hiw well made it appears to be & from reading comments after I asked about them here I recently ordered & received 2 DNC mounts, 1 for my Contender 14" 44mag bbl & 1 for a Ruger 10/22. I've mounted them with scopes but haven't had a chance to shoot either one yet. After installing the mounts on each gun I tested the relation of the front & rear rings to each other with my scope lapping tool & found they were perfectly aligned so no lapping necessary! I like the look of the DNZ much better than a pic rail, too bad they don't offer mounts for CZ's
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
