Amazon.com : Uncle Mike's unisex adult QD 500 Blued 1' Bolt Set, Clam Mossberg 590 835 Swivel, Black, 1 US : Baseball Caps : Sports & Outdoors

Shop Amazon for Uncle Mike's unisex adult QD 500 Blued 1' Bolt Set, Clam Mossberg 590 835 Swivel, Black, 1 US and find millions of items, delivered faster than ever.

www.amazon.com

 

Thank you. Will that fit the 20 gauge? Or can I remove the front sling stud from the magazine cap?

 

I got one off ebay for a 500A cheap, and quick

 

Do the newer mossberg forends still rattle like the old ones?

 

Yes, both 20 gauge and .410. The 20 gauge was used, but still had a factory sticker. The .410 was NIB. Both rattle like my old 12 gauge.

 

looks like yes from one of the review.

 

If you remove the forend, take spanner nut off (I use a butter knife), remove wood from inner action tube you'll see 4 dimples at rear of tube. You can take a rounded punch and slowly tap the dimples in tighter. Don't go to far. It really takes a lot of play out of it reducing the rattling. The action arms are noisy, because they're riveted on. I never found a fix for that. They are reliable shotguns, and I like the tang safety.

 

If all you need is the stud, I have one that may work. I have the model 510/410 and assume it would be the same for the 20. It's free and I can get it headed your way tomorrow in snail mail.

 

Before I posted, I called Mossberg and I was told I needed part 12030.
Quick-Detach Stud, Front O.F. Mossberg & Sons
I was told there is just a single size.
That's a very generous offer. I will PM you. Thank you.

 

Thought I'd post on here what I done to my mossberg 835 to quieten it down as far as play in the forearm. I've posted in other forums over the years about it but it doesn't get brought back up often. You can get different size furniture sliders at your local wal mart or hardware store. I used the 5/8" by 3" or 4" approximately. Cut in half lengthwise and install along the top of the forearm on each side of the barrel. They are self adhesive and if you clean the barrel first they will stick quite well. After you put one on each side of the forearm you can put a third piece at the front of the forearm that will act as a cushion or stop as well. It's a night and day difference if you put them on the right way eliminating most of the play and silencing any excess noise. I still have the original ones on my 835 I installed 7-8 years ago.

 

Good tip kyrimfire22. Thank you for sharing with the rest of us.