Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,793 Posts
I have used the BKLs and would recommend them heartily - they are cheap and very effective on either 11mm or 3/8" dovetails. The rings are designed to keep the scope centered over the bore. They are tall enough to take many large scopes in stride. Hard to beat for $18 and a great one to have on-hand.


I'm currently using a set of my old high adapters with Burris Signature Zee Rings in high. I could probably use mediums but the highs are comfortable for silhouette shooting.

Don't forget the Millett CZ ZKM rings that are designed for the flat receiver and 11mm dovetail.

If you need high rings the Beeman 5030H are the tallest I have seen.
 

·
Registered
Joined
·
1,793 Posts
One thing you are probably aware of already is that the scope is likely to interfere with the rear sight base. You can remove the rear sight easily enough but you will likely need to go with higher rings that you might use on an American or Varmint to get the scope objective clear of the rear sight.

I might have an old prototype of my high adapters around if you'd like to give them a try. Most likely the low ones will be too low with the rear sight and the big objective.

I was also wondering whether the rear sight base is in the same place on the Ultra as it is on the Lux and Special? If so I imagine they had to recalibrate the sight ramp to work with the longer sight radius. If the base if farther foward it might not be the same problem as on the Special/Lux.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top