Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
Hi folks,

My VQ parts have arrived :) Extractor, extended magazine release and automatic bolt release.

So - will I have any problems fitting these? I've got no instructions on installation so I'm working with what I can see :)

Barclay
I like work; it fascinates me; I can sit and look at it for hours
 

·
Registered
Joined
·
20,556 Posts
Barclay......

Shouldn't be any "fitting" actually required. Should be just a straight parts swap situation.

If you have never removed an extractor before, I'd strongly suggest doing it inside a one gallon Ziplock baggie. If it gets away from you, you'll never find all three parts.

Ron
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #3 ·
Well, I've managed to install all the mods and with a second attempt I even fitted the VQ Extractor :)

I'll have to pop down the range soon and make sure it's all working correctly :)

Barclay
Rotten wood cannot be carved
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top