Rimfire Central Firearm Forum banner

TORQUE value ??

274 Views 1 Reply 2 Participants Last post by  USA Varminter
have a 922M semi that has two hold down screws and am wondering if there is or should be a torque down setting. would like to use cap head type screws but dont know the thread #. would the setting be the same on both screws, or would the front be diff from the rear screw ?? anyone have any input ??

thanks all

1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.