Rimfire Central Firearm Forum banner

Torque Settings?

351 3
I posted the following in stocks and I thought I would post here!

Search is disabled and I was going shooting tomorrow.
My Ques:
Playing around I removed the heavy barrel from my Ruger 10/22T.
What would be the good torque settings when I reseat the barrel??
Any help would be appreciated – also what torque have you been using for the action screw?
Thanks in Advance.
1 - 4 of 4 Posts

·
Registered
Joined
·
3,642 Posts
V-Block Screw Torque

Pilot,

The barrel retaining V-Block screws [#12-24] should be tightened "hand tight" [per Ruger]...! ! :rolleyes:

I would recommend 20 Inch Pounds on these screws as they are threaded into soft aluminum...! ! :)

Hope this helps...! ! :)
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top