Rimfire Central Firearm Forum banner
1 - 1 of 10 Posts

· Registered
468 Posts
What is the advantage of that wrench over the Wheeler? And how reliable is a torque measurement from such an angle? Probably measures a tad high?
Not sure about the one posted above, but I use a CDI torque driver which is very sleek and similar to the other. It is adjustable from 5 to 60 in 1 inch/lb increments.


The "fat" wrench is aptly named and is marked with 5 lb adjustments which is fine for the most part, not so good if you want to tweak performance by experimenting with action screw torque.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.