Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
20,556 Posts
Volquartsen : is about the only one .
Unless you find a custom smith that will start out from a .920 blank , threat the shoulder and mate it with your receiver.
The receiver must be threaded to accept the barrel. Therefore
a standard receiver results in a bigger shoulder size on the barrel. For this reason , there are not many willing to offer a pre threaded barrel in aftermarket sales.
 

·
Registered
Joined
·
1,058 Posts
Randy @ CPC will make a custom threaded barrel from a blank, thread the receiver and match the barrel to it, for 10/22 & 77/22 only. Randy has posted that his web page is out of date so you should contact him to discuss the job & get the price.

Regards Bill:)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top