Rimfire Central Firearm Forum banner

Stoney point target knobs

422 3
Has any used these? How is the quality? Also once dialed in can you reset the dail to zero? I was thinking of getting a set. Thanks.
Bill
1 - 4 of 4 Posts

·
Registered
Joined
·
431 Posts
johnnydog72

I have not had any trouble with mine slipping. Not sure about the newer ones but my old set has two set screws, one on each side. I just torque them down slightly once I have the knobs re-zeroed and they have never moved even the slightest on me. You might check the screws to see if they are tight, that could be causing your slippage trouble.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top