Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,622 Posts
Discussion Starter · #1 ·
Hey guys,

I have a supermatic citation that I have a Tasco dot scope mounted on the barrel. The mount I'm using is really a jerry rig set-up, and I'm just curious as to what others might be using in a no-drill & tap mount?
 

·
Registered
Joined
·
303 Posts
I have a High Standard Universal Scope Mount that has been laying around awhile and never been used. You can have it for $30.00 (my cost was $40.00 from High Standard). Send me a private message if you want it.
 

·
Premium Member
Gunsmithing 10/22's and 77/22"s since 1994 Phone 1-860-343-0552
Joined
·
1,329 Posts
For dot sights that are made for the 3/8" Tipoff base, also known as Rimfire scope mounting, I just cut the base right on to the barrel... Lowers sight as low as it can be and works well... Ends up being two lite lines on barrel that are not noticable...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top