Rimfire Central Firearm Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
I haven't seen up close any scopes mounted on revolvers, so I don't know how it is usually done.

Is it possible to mount a scope on a High Standard Double Nine revolver?

What would be needed to do it?

What mount(s) would work?

Would you need to have the frame drilled and tapped above the cylinder?

Thanks!

(I'm new to the forums so I'm not sure if these questions are more appropriate here or on the High Standard forum.)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top