Rimfire Central Firearm Forum banner

S&W 647, 17HMR, Scope Question

256 2
:) Am looking for a ring base that will fit in the rear sight groove once the factory sight is removed and that w/also align with the screw holes that held the olriginal sight in place. What have some of the board posters done to install a ring base on the 647? Many thanks for your input!
1 - 3 of 3 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top