Rimfire Central Firearm Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,870 Posts
davr said:
I was able to find some time and answer my own question I guess on the scope mounting, finding Weaver's TO-10 base and a couple options from BKL.

My concern is with the Weaver, and the set screws. I'd hate to spend $200 on a new finish just to have the set screws mar it up. Is this the case, or if care is taken will the set screws not mar the finish? Once on I don't expect I'll ever take the scope off, but still, marring a new finish does not appeal to me.
davr, I cut a out a peice of aluminum flashing and slid it under the mount on my two 9422's to keep from marring the finnish with the set screws.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top