Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
630 Posts
dcc.....I was advised that I could install one in a short matter of time even with 4 left paws............

100 % Drop-in. No cutting, grinding or fitting
10 oz. to 2 lbs.
Uses factory Safety
Complete with all parts & instructions

http://www.varminthunters.com/riflebasix/

Call them...........I did.......
 

·
Registered
Joined
·
71 Posts
Hey,

I got my rifle basix trigger yesterday and it took about 20 minutes to install and adjust. Real simple. I set it without the use of a trigger pull gauge and when I checked it today it consistently broke at 1.25 pounds. That is one crisp trigger. Still it was safe and would not slip even if bumped, cycled fast or pulling on the trigger with the safety on and then letting pressure off the trigger and pushing the safety to fire. I'm happy with mine and I'd highly recommend it to anyone with a Marlin rifle, .17 or .22/.22 mag.

Bill
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top