Rimfire Central Firearm Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
Hello folks,

I am in need of a replacement seer spring. Do any of you folks have one that you would be willing to part with?

I recently bought a used 597 SS. Previous owner botched up a trigger job. Hammer doesn't reset right. Factory hammer stoned incorrectly too. (Got new one coming. Many thanks to AnchorageAk!). Further teardown to see what else was going on revealed a cut and crushed sear spring.

Thank you and kind regards.
 

· Registered
Joined
·
3,796 Posts
Don't have one, but I did the adjustable sear routine in the sticky, and used a spring from a 100 pack of assorted springs from Lowe's--whole thing went about $4.00. Try just the spring (one that's close or cut one down) and see.
Wanna buy 99 springs :D

Do a drop test afterwards though!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top