Rimfire Central Firearm Forum banner

Preparing to make first Ultimate

426 Views 5 Replies 5 Participants Last post by  AK
I am getting ready to make my first ultimate. I just ordered a 20" GM blued Bull barrel today and will be picking up my 10/22 (standard version with blued barrel and wood stock) and am going to be ordering the a Revival industries Yukon Stock in Cayenne (i think that is how you spell it) in the next few days. I will also be ordering a VQ hammer and maybe a glassbed kit. Are there any suggestions or any other parts that are a must have?

Thanks
1 - 6 of 6 Posts

· Registered
Joined
·
8,058 Posts
parts

weapon craft action screw and buffer 15.00?
titanium extractor 12.00(ebay)
a trip to randy at cpc for your bolt 50.00
 

· Registered
Joined
·
5,438 Posts
Like MarkD said the VQ mag release is very nice and after using a couple different plastic one's I won't be switching back. A WeaponKraft buffer and some JB Weld should get you started off good.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top