Rimfire Central Firearm Forum banner

New to 10/22's Need Help

277 Views 3 Replies 4 Participants Last post by  Fan of 22s
Hey everyone; I just picked up a used 10/22, and now need a hand on how to trick it out. I already ordered a heavier bull barrel, as well as a thumbhole silhouette stock from Eabco. First off though I need to know how to properly dissemble my stock 10/22, and then how to fit it all into my new stock and barrel. Thanks alot for your help, there are some great looking guns here.
1 - 4 of 4 Posts

· Registered
Joined
·
6 Posts
There's a take-down screw in front of the trigger guard on the bottom of your stock - unscrew that. Set your safety so it's in-between on and off (equal parts sticking out of either side of the trigger guard). Pop it out the whole works.

You should have a barrel, receiver, and internals (action/trigger group) in one hand, on the other you should have a completely stripped stock.

Beyond that, for removing your trigger group, bolt, bolt handle, barrel...etc - refer to your owners manual. The directions in there are just as good as anything I'd type here.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top