Rimfire Central Firearm Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
Well I installed a PC adjustable sear and hammer kit with all the springs and shims. I radiused the trigger plunger and installed a VQ trigger. The pull is smooth and the break is crisp. My only problem is it fires in 3 to 5 round bursts. I removed the action from the hogue stock and it worked perfectly (fired 10 rounds slowly), put the action in the factory stock and it worked perfectly in it as well (10 rounds fired slowly). Why would it suddenly start doing this?

Thank you

Will
 

·
Registered
Joined
·
21,852 Posts
Sounds odd...never seen stock pressure cause bursts :eek:
Kinda fun though aint it :D
Just a thought..did ya get oil/lube on the hammer/sear area? I know it sounds stupid but as lite as mine are if I get excessive or actually any oil in that area I get bursts.
 

·
Registered
Joined
·
22,045 Posts
sounds like the set screw on your sear is screwed in too far. try turning it out a tad and see. hope you have a hole drilled out in the trigger or this procedure
can be a bit of a pain,

Rico....








 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top