Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
What sequence should I tighten the three bolts in if I need to remove the stock and replace it. I have bought the rifle secondhand and don't have the original paperwork that comes with the rifle.

Many thanks
 

· Registered
Joined
·
350 Posts
Stock screws

Only the front and rear screw into the receiver. The middle just screws into the stock to hold the trigger guard. As far as the sequence, I always start with the front. I snug them both down fairly tight and then cinch the front down. I've never had any problems with accuracy or change in POI.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top