Rimfire Central Firearm Forum banner

MKII Trigger help

1K views 7 replies 6 participants last post by  Jaeger 
#1 ·
My Brookie improved CZ and Kidded 10/22 have spoiled me.

Just dropping a Volquartsen hammer into my other 10/22 was a great help.
Is there a similar inexpensive improvement for the MKII?
 
#3 ·
from this page:

http://www.ontargetguns.com/mark.html

I would reccomend (and have them myself)
the trigger shield to help keep gunk off of the trigger parts
http://www.ontargetguns.com/otts.html

target sear to help the break and pull:
http://www.ontargetguns.com/vts.html

I got the hammer also, but not sure if it was needed:
http://www.ontargetguns.com/vsh.html

and a better extractor:
http://www.ontargetguns.com/veex.html

also if you don't already know, here is some Ruger MKII stuff:
http://www.1bad69.com/ruger/index.htm
 
#5 ·
Goodwrench,
I also like "On-Target"
I had Bill do the following to my Ruger Mark 1(s) and Mark 2(s).

Added:

Clark Trigger
Volquartsen Sear
Trigger Shield (also recommended by yzguy)
Extended Magazie Release

I had Bill install all of these and got what I think
is a great deal.
He did all four of the above mentioned upgrades
on three (3) Ruger frames plus added the trigger guard and extended magazine release to another Mark 2 for a total of $20 labor for all four guns.
The total (parts and labor) for all four..$201 (this included the return freight)

I've shot the heck out of a Mark 2 I sent to him a couple years ago and never once regreted that upgrade. (at that time I just had him add the sear and trigger).

I'm sure you can always shop and find a better deal, but I went with several recomendations and felt the deal was good for me since I'm not a 'smith.
VF
 
#7 ·
JohnKSa,

The transfer bar mod gets rid of a take up, with the overtravel screw - the total trigger travel (measured at mid point) is less than 3/32" (more like less than 1/16"). A lot of consideration must be given to sear / hammer clearance (overtravel screw) and sear reset (xfer bar). 1911 & HS Citation/Victor shooters (amongst others) are used to short trigger travel.

HTH
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top