Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,182 Posts
Say goodwrench,

Snoop back thru last year's posts for Sumshooter's post. He did a mod on the trigger transfer bar, with an overtravel screw it breaks like a match 1911 trigger. Last one I did was for an old time Steel Challenge shooter's MK I.

HTH
 

·
Registered
Joined
·
1,182 Posts
JohnKSa,

The transfer bar mod gets rid of a take up, with the overtravel screw - the total trigger travel (measured at mid point) is less than 3/32" (more like less than 1/16"). A lot of consideration must be given to sear / hammer clearance (overtravel screw) and sear reset (xfer bar). 1911 & HS Citation/Victor shooters (amongst others) are used to short trigger travel.

HTH
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top