Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
235 Posts
Thanks R.J.! I think I will give it a try. :D

I have made several of the Tips and Tricks modifications and installed a Volquartsen hammer. My trigger pull went from "off the scale" on my old spring type guage to 1 1/4 pounds! Although I tested for safety and could find no problem, I felt that this was just too light. I replaced the Volquartsen trigger return spring with the original spring and it went back up to 2 pounds, which is fine with me.
I do have a lot of take up in the trigger which I would like to reduce. I did the J-B Weld trick but that didn't help much.
Any suggestions or do you guys just get used to the take up?

GHP
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top