Rimfire Central Firearm Forum banner
1 - 1 of 1 Posts

1,160 Posts
Lazarus said:
Can anybody tell me the approximate final thickness of the JB Weld once it has cured and been sanded to fit ? I know everybodys will vary but I just want to be close in range so I do not have to file to much off or apply too little.

Thanks for the help

Low end: 1/32"

High end: 1/16" (((Approximately, of course. They all differ a bit.)))))))))

..at least that's how mine worked out
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.