Rimfire Central Firearm Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter · #1 ·
Can anybody tell me the approximate final thickness of the JB Weld once it has cured and been sanded to fit ? I know everybodys will vary but I just want to be close in range so I do not have to file to much off or apply too little.

Thanks for the help

Laz:)
 

·
Registered
Joined
·
115 Posts
put some on there and wait untill it gets like a putty consistancy and it wont stick to your fingers , Than put the disconecter on the sear and that should mold it to the proper shape .
 

·
Banned
Joined
·
1,161 Posts
Lazarus said:
Can anybody tell me the approximate final thickness of the JB Weld once it has cured and been sanded to fit ? I know everybodys will vary but I just want to be close in range so I do not have to file to much off or apply too little.

Thanks for the help

Laz:)
Low end: 1/32"

High end: 1/16" (((Approximately, of course. They all differ a bit.)))))))))

..at least that's how mine worked out
 

·
Registered
Joined
·
730 Posts
Hoosierdaddy

PM me with your email addy and I will send you a Word document with the pics and directions, also some other useful stuff from this site that I have used in working on my 10/22s.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top