Rimfire Central Firearm Forum banner

How do I remove the safety?

693 Views 10 Replies 8 Participants Last post by  Chaser
I am in the process of polishing my target 10/22. I can get everything out and apart except the **** safety. I was able to get it to roll/spin so I could slide it more, but I couldn't get it out. I have seen from pictures that it is possible to get out, and thus I would assume possible to put back. Any help would be appreciated. :) I looked in the takedown sticky but it hasn't gotten to that point yet.

Ed
1 - 2 of 2 Posts

· Registered
Joined
·
4,886 Posts
It's a little tricky. You should be able to see the plunger under the safety rod. You need to turn the safety until there is a section of full diameter over the plunger. In other words, where the plunger is not over the notch. Then you can pop it out. Make any sense?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top