Rimfire Central Firearm Forum banner
1 - 4 of 21 Posts

· Registered
532 Posts
Though after I drew up the dimensions I decided to draw it up on Tinkercad and then print it off on my 3d printer. I printed it on the lowest resolution just to see how it came out. I could make it print much nicer but it would take longer to print. This took about 15 minutes to print. Functions fine. Just not to pretty. LOL

TinkerCad drawing

3D Printed loader.

Back side. Though you can use it either side.

Here it is ready to drop 10 round in the mag!
1 - 4 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.