Rimfire Central Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,905 Posts
Discussion Starter · #1 ·
I sometimes get feeding problems with my 77/22 mag. It seems like the case is sticking on the bolt face or ejectors. When trying to chamber the round it binds because it didn't go all the way up into the ejectors. If I pull back a bit then try again it goes in just fine. Any clues as to the problem. I'm thinking maybe the mag is a little sticky and not pushing up hard enough....
 

·
Registered
Joined
·
2,835 Posts
Also might want to clean the extrators

with a shot or two of spray cleaner.

Make sure they are in good work'in order.
I like Hornady OneShot,but Rem oil or
some of the others will work fine.

Flush out then work them with your
finger,then flush again.

It's suprise'in how much gunk can collect around them.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top