Rimfire Central Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 · (Edited)
So I take out the factory extractor and without thinking I put it down next to the VQ extractor I'm going to replace it with.

Then I realise I didn't notice which was which - So I now have 2 extractors I can't tell apart.

The visible difference is one has a little groove on the side that sides into the bolt near the spring.

Any ideas ?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top