Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
143 Posts
Page 17 of this document.

Personally, I tend to simply raise the bolt handle and pull the front trigger. No chance of misfire, and the whole system is reset once you bring the handle back down. :bthumb:
 

·
Registered
Joined
·
143 Posts
Haven't been able to provoke that behavior from my '18 either.

I also can't work out how it's happening - I can unset mine with the safety off and taking no particular care, without the hammer falling using the 'silent' technique.

I actually found that if I have even the most cursory hold on the rear trigger, when I release the front, the hammer doesn't drop - so much so that it's almost harder to set the rifle off from the set state with your forefinger on the rear trigger, than it is to unset it.

Clearly something amiss in your setup I'm afraid.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top