Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6,719 Posts
Discussion Starter · #1 ·
So I sent my trigger group off for a $40 trigger job I ran across on Gunbroker. I must say I am extremely pleased. My VQ TG2000 is certainly not worth the extra $160, nice as it is. There's a tiny bit of slack to take up in the cheap job, but the letoff is crisp and light. This guy, Don Barnes, will get my next one, too. The GB site is screwy tonight, but Don's email address is [email protected] Two-week turnaround.

The original listing was: "Ruger 10/22 Match Trigger" :2p
 

·
Registered
Joined
·
6,719 Posts
Discussion Starter · #3 ·
RX7-2nr said:
what all did he do to it?
SERVICE INCLUDES THE FOLLOWING :

1) COMPLETE DISASSEMBLY AND *ULTRASONIC* CLEANING OF YOUR TRIGGER GROUP.

2) TOTAL INSPECTION OF ALL TRIGGER GROUP PARTS.

3) HAMMER AND SEAR ANGLES *DIAMOND* CUT TO PERFECT 90 DEGREE ANGLES FOR THE BEST POSSIBLE *MATCH* GRADE TRIGGER PULL.

4) HAMMER AND SEAR SURFACES *MICRO* POLISHED FOR OPTIMUM TRIGGER PULL PERFORMANCE AND RELIABILITY.

5) TRIGGER GROUP IS RE-ASSEMBLED THEN LUBRICATED AND TESTED.

6) TRIGGER PULL WILL BE REDUCED FROM A *STANDARD* 6 - 8 POUNDS TO A *MATCH* GRADE 2.5 TO 3 POUNDS !!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top