Rimfire Central Firearm Forum banner
1 - 1 of 1 Posts

· Registered
2,217 Posts
Discussion Starter · #1 ·
I was looking down the chamber of my 10/22 and noticed an interesting thing. The transition into the rifling seems to be a 90 degree angle. The rifling is cut into the bullet instead of being pressed by a quick but angled transition. Is anyone doing a slight chamfer on the leading edge of the rifling to avoid cutting lead off the bullet and instead pressing the rifle into the bullet? Are all chambers constructed the same?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.