Rimfire Central Firearm Forum banner
1 - 1 of 10 Posts

· Registered
885 Posts
Didn't someone a while back figure out a way to D&T the bottom of the receiver and make a screw in replacement stud with the cross hole?
Yes, that is one way to fix it. Drill/tap and loc-tite a small bolt in. Cut it to length, drilling a new hole and fileing it so the trigger will go over it.

Tig welding the part back on is another way. I wouldn't trust epoxy...

1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.