Rimfire Central Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter · #1 ·
ok got my new parts today and putting it all back together :)

I watched carfully how the bolt lock spring came out but whats the trick of getting it back in? seems there is no tension to hold it. or does it go back in after the hammer?

I looked at the stickys and taking it apart was a snap with the diagram(thanks chief) but that spring is whats got me going.
 

·
Registered
Joined
·
129 Posts
Discussion Starter · #4 ·
Cool

yep got it all back together. I can tell by dry firing that the trigger is alot lighter. and the bolt release and extended mag release is nice. :)

now out to spend some $$ on the barrel and stock :) oh yea and scope rings :)

wasn't too bad. I think I did pretty good for being the first time to tear it down.

I will say that I'm glad I read the match stick trick for lining up the trigger and sear to the housing. That was priceless.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top