Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Wheres good place to get your bolt chamfered? I would also like to get the face squared and the rest of the bolt polished.

Any takers?

Is this maybe something I can do at home?
 

·
Registered
Joined
·
20,556 Posts
A great many of them are done at home, but the success of which depends entirely on your ability to accurately grind metal. yes, it can be done by hand (by some people) Take a look at the Tips and Tricks section. That will give you a better idea of whether you want to try it or not.

Or, you could check with Randy at CPC here on the site. His reputation is great.

Ron
 

·
Registered
Joined
·
270 Posts
I have chamfered several bolts using a dremel. They didn't come out too bad. Once done, I went over them a few times with a fine stone.

Or, like said.....send it to CPC :D

KillJoy
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top