Rimfire Central Firearm Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter · #1 ·
Has anyone tried to or think it would be a problem to bed a plastic"carbon fiber" barrel.

Thanks
 

·
Registered
Joined
·
151 Posts
Discussion Starter · #3 ·
A BC ultra-lite, I was wondering if the the releasing agent would work or if there may be solvents in the epoxy that would melt the palstic or some such.
 

·
Registered
Joined
·
909 Posts
I don't know about BC. I used PVA Mold Release Agent on my Magnum Research barrel to release it from Marine-Tex and it worked fine. You can always use saran wrap if you're unsure.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top