Rimfire Central Firearm Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
:( i saw a lot of bedding techniques in this forum & i learned a lot from it. my question is why is it that either the pillar is drilled & enlarged or only the screw area is metal or jb bedded. why not use the metal trick in the whole area from the screw to the "v" block or lug so that the whole action is sitting on a wide & hard surface area ..... then bed the barrel channel 2-3"... :( any comments? .... ideas ... advices ? :confused: thanks.....
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top