Rimfire Central Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
After looking at the manual it appears that the first couple inches of the barrel have been turned down and a sleeve with the front sight slid on it. I'm thinking about cutting the barrel off right behind the front sight. I like the long tube but I like 'em smooth. Gotta get rid of that rear one too, interfears with scope mounting.
 

·
Registered
Joined
·
28 Posts
Greyeagle, I'm wanting to mount a 44mm scope with an AO. I tied to fit it with the ladder off but it was a no go. I could use higher rings but I like to keep my scopes as close to the bore as possable. Besides I already have a set of Burris signature Zee rings I'd like to use. Tom.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top