Rimfire Central Firearm Forum banner

Anybody have this scope/base/rings setup

579 Views 5 Replies 5 Participants Last post by  OldCorpsJoe
Hi everybody,


I have a Simmons 1047 (same as 1048 44mm) with T09 base and Weaver DTM high rings. As i read on the RFC forum, this set up was supposed to be OK, but 1/32 is missing to clear the big AO ring.

My question is: Should i buy a Millet or a PC base or should i go with Extra High mounts??

Thanks a lot.

Erick.
Hi everybody,


I have a Simmons 1047 (same as 1048 44mm) with T09 base and Weaver DTM high rings. As i read on the RFC forum, this set up was supposed to be OK, but 1/32 is missing to clear the big AO ring.

My question is: Should i buy a Millet or a PC base or should i go with Extra High mounts??

Thanks a lot.

Erick.
See more
1 - 1 of 1 Posts

· Registered
Joined
·
16,533 Posts
I have a Simmons 800116 8x32-44mm on a Weaver base and Weaver DTM Extra High rings on my 10/22HB. Works well for me...about 1/4" clearance. Looks like the cheapest/easiest way out for you........JL
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top