Rimfire Central Firearm Forum banner

Anybody have this scope/base/rings setup

575 Views 5 Replies 5 Participants Last post by  OldCorpsJoe
Hi everybody,


I have a Simmons 1047 (same as 1048 44mm) with T09 base and Weaver DTM high rings. As i read on the RFC forum, this set up was supposed to be OK, but 1/32 is missing to clear the big AO ring.

My question is: Should i buy a Millet or a PC base or should i go with Extra High mounts??

Thanks a lot.

Erick.
1 - 2 of 2 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #4 ·
Thanks for the fast reply

"Power Custom": _ .432" high
"Weaver" TO-9 : ~ .125" high
Difference: _______.307" gain
_________________________________________________

0.432 for the PC wow it's almost 1/2 inch high!

Now if someone know how high is the Millet i would really apreciate. I checked their website for part RU00701, but no luck.

Thanks!

Erick.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top