Rimfire Central Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2,045 Posts
Discussion Starter · #1 ·
The bench 10/22 is slowly coming together. CPC has my bolt. I put the barrel on today and drilled and tapped it for the PC 6 hole mount. The Odyssey stock sits in the corner and beckons. I tapped a hole in the back of the receiver to tension the my new KIDD trigger on the action pins. I get my bolt back, I'll chamfer it, and get it all together. We will see if it gets a score shot this month!?!?!?

So far, the build list is this:

10/22 action
Bell & Carlson Oydessy Stock
KIDD Trigger
GM Fluted Stainless 20"
CPC bolt work
Trigger group to receiver tightening set screw
Chamfer bolt
Wet-lapped fring pin
VQ Extractor
PC Ti bolt handle
VQ compensator
PC 6 hole rail (Sweet idea)
Burris Signature ZEE rings
Currently a Jap 8-32x44 Tasco Silhoutte
Saving for a ???? 36X
Will bed as needed when all done....

Wow, ain't this fun!!! I'm dying to get to shootin
:D :D
 

·
Registered
Joined
·
2,045 Posts
Discussion Starter · #3 ·
I talked to him recently about it, he said he was trying it for a few folks. I told he could do it if he wished, otherwise I would. I am anxious to see the jeweling in the finished rifle.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top