Rimfire Central Firearm Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
5,084 Posts
Action Screw and V-Block Screw Torque Specs

santino,

"Ruger" customer service recommends 'hand tight'.....? ? :eek:

I always recommend 20 INCH pounds each for the two V-Block screws, and 30 INCH pounds for the "Take Down Screw".
[ 12 INCH pounds = 1 FOOT pound ]

All are #12-24 thread, and going into a soft aluminum receiver.

Do Not over tighten.....! ! :eek:

Hope this helps.....! ! :)
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top