Rimfire Central Firearm Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I Am Looking To Finish Off My 10/22 W/ New Scope Rings And Mount.

I Need Somethins That Will Clear A 44mm Objective.

Was Looking At The Burris Signature Weaver Style Med High
And The Weaver T-09 Base... And Sugestions Comments Or Possible Upgrades To This Set Up...

Thanks

Dave
 

· Registered
Joined
·
3,017 Posts
slawdog said:
I Am Looking To Finish Off My 10/22 W/ New Scope Rings And Mount.

I Need Somethins That Will Clear A 44mm Objective.

Was Looking At The Burris Signature Weaver Style Med High
And The Weaver T-09 Base... And Sugestions Comments Or Possible Upgrades To This Set Up...

Thanks

Dave
I used the PC base and Burris Sig Zee rings in med height. The PC base and the Weigand Picatinny style base both have more cross slots. This allows for more ring spacing options. I'll use the Weigand base on my next one. :t
 

· Registered
Joined
·
3,500 Posts
Like Fullchoke I use the PC base and med Burris Sig/zee rings. I use a Tasco 6X24X44 TS scope and have plenty of clearence.

Dave Z.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top