Rimfire Central Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,605 Posts
Not me, but good luck!

I think what you are looking for is called a blueprint. Might try looking here:

http://www.rimfirecentral.com/forums/showthread.php?t=74731&highlight=stock+blank+inlet

http://www.rimfirecentral.com/forums/showthread.php?t=68868&highlight=stock+blank+inlet

http://www.rimfirecentral.com/forums/showthread.php?t=68469&highlight=stock+blank+inlet

I think most people end up cutting, chopping, shaping, gluing, bolting, screwing, epoxying, bondoing and what-not on a cheap factory birch stock.

I wish you the best on your project, kudos to you for starting from scratch!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top