Rimfire Central Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,093 Posts
Nope, not without considerable machine work/modification. The shank on 77/22 barrels is about 1/8" longer than 10/22's, thus would not provide proper headspace. Additionally, even if you used a lathe and extended the shank, the v-block notch would then be too short. Most probably has been done sometime but I'd think it wouldn't be worth the trouble.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top