Rimfire Central Firearm Forum banner

Rimfire pistol pic thread

617K views 1K replies 586 participants last post by  Bear-of-Grayling 
#1 ·
Let's see your .22 pistols.......I'll get the ball rolling.

Top: Clark custom ported barrel Ruger MKI w/Fitz grips,Volquartsen sear,hammer,& trigger

Mid: Pac-Lite barreled Ruger MKII w/ Hogue grips

Btm: S&W Mdl. 41
:comeandge
 
See less See more
1
#104 · (Edited)
kozak6 said:
Nope. It does take 10/22 mags, though.

It's an Intratec TEC-22.
That's right! and there are no more of these being made to my knowledge. I imagine only a few hundred are out there.

As for my Tec-22, I have an extra firing pin, but no firing pin spring, which is causing a lot of FTFs. I will probably use an improvised spring from: www.smallparts.com - Originally, I was going to try to use grease, but when I looked at the manual, it clearly shows that a firing pin spring is to be used (I couldn't remember). I had this gun in my closet for years, but have decided to get back into shooting since my two small girls are more independent and I have more free time. All this gun needs is a small spring to keep the firing pin out.

A general-purpose spring beats buying a 5-cent OEM item for $30.00 when I can use and alternative. I figure if the gun will function 50% with no spring, a simple cut to length spring should provide much better firing pin
performance.
 
#110 ·
From top:

1959 Colt Woodsman Match Target 3rd Series 6" w/ factory grips
1974 Colt Huntsman 3rd Series 4.5" w/ factory grips
1956 Colt Woodsman Match Target 3rd Series 6" w/ Herritt Target grips

Bought the Huntsman for $100 used in 1975 or '76. For thirty years I've longed for, lusted after & craved a Match Target- this month I fixed that. I bought two!

 
Top