What is that thing on the bolt knob? I am interested in what you find out, one of mine will extract for sure, but almost never throws the case out of the loading tray.
The ejectors on the 54 match rifles all work the same, they are inserted into the loading block and kept in place with the spring from underneath the receiver.
If you can't find the parts anywhere, lmk.
That is a single extractor bolt, do you need an extractor or ejector?
He obviously meant single extractor bolt, as I realize when I see your question. The extractors are the same as the current ones and he will most likely also need the spring and guide pin. ANA should have them.
I think a single extractor bolt has only one extractor/ejector. I'm just looking for help in locating a replacement not not being made out to be a dumb azz.
I think a single extractor bolt has only one extractor/ejector. I'm just looking for help in locating a replacement not not being made out to be a dumb azz.
Frank
Frank,
Properly the claw on the bolt is the extractor. The ejector is the little stud in the breech that AndyD pictured. These aren't the same thing, so the replies were genuine attempts to determine exactly what you want. I didn't read any sarcasm or condescension into their replies.
Linear Mode
