Removing a tight barrel the easy way (big pics) - RimfireCentral.com Forums

Go Back   RimfireCentral.com Forums > >

Join Team RFC to remove these ads.
Closed Thread
 
Thread Tools Display Modes
  #1  
Old 03-09-2005, 07:24 PM
Matt-man
NRA Member - Click Here To Join! GOA Member

Join Date: 
Sep 2002
Location: 
Phoenix
Posts: 
229
TPC Rating: 
0% (0)
Removing a tight barrel the easy way (big pics)



Log in to see fewer ads
Ever had a really tight-fitting barrel that didn't want to come back out of the receiver? I have. This time it's a Volquartsen that I installed with a mallet. I wanted to fix the beat-up finish on the receiver so I needed to separate the barrel from the receiver.

I decided to build a fixture that I could put the barreled action into, and press the barrel out instead of trying to push the receiver off the barrel with a mallet. It's simple, and works pretty well.

You need:
  • two 1x1 pieces of wood, one about 2" long and the other about a foot
  • a short length of 5/8" dowel
  • a flat piece of wood - I used a 1x4, a 2x4 would work too
  • a 1/4" x 2" plank
  • a 5" C-clamp

First thing to do is drill a 1" hole in the 1x4. This is for the barrel. You'll need to elongate the hole so the receiver block can fit through it as well. Position the 1/4" thick piece next to the hole so the receiver "foot" is supported, and fasten it down so it doesn't move. It ends up looking like this:



Here you can see how the barreled action fits, and how the 1/4" thick piece supports the "foot" of the receiver:



Next step is to cut a piece of 5/8" dowel to about 1 1/2". This is the part that contacts the breech and pushes the barrel out. Set it on top of the breech. Make sure it's centered pretty well, otherwise it will catch on the receiver as the barrel pushes out. If you wanted to get fancy you could put a pilot on the dowel to keep it centered on the barrel.



Now you need two pieces of 1x1, a long one and a short one. The long one is the lever of the press, and the short one is the fulcrum. The lengths aren't really critical. Arrange them as shown here:



Now, you can crank down with the C-clamp and as you do, the lever will put pressure on the dowel, which will in turn push the barrel out. Just be careful not to let the barrel hit the floor when it comes out!

In my setup the lever started bending but didn't break. I guess you could substitute 1" square steel tubing if the wood isn't strong enough.
Closed Thread

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off




All times are GMT -5. The time now is 12:57 AM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x