Rimfire Central Firearm Forum banner

Remington 552 Speedmaster magazine screw

1K views 3 replies 3 participants last post by  Wanderson 
#1 ·
Does anyone have a magazine set screw for a Rem 552 or know who might be still making/stocking these?

Mine has corroded to the point that the threads are gone on the screw and won't tighten but the threads inside the magazine hanger look fine.

I can't find one anywhere on the internet.

Thanks in advance for any help.

BBQ
 
#4 ·
Gun Parts

I'd start with Numrich Gun Parts, if nothing else a good source for schematics.
I looked for a replacement rear sight for my 552 for two years before Numrich listed some reproductions.

eBay & other action sites like Hibid is also a good source for parts especially small screws but again, patience.

Be flexible, Remington made more than one tube fed magazine model, so don't just focus on a 552 when a 512 MIGHT work. It's a gamble, but most manufacturers kept it simple and used the same parts in different models, even though most schematics don't show it.

I just got a Marlin 80 running, after buying a replacement striker assembly from Numrich I was still missing the one screw that holds it in place, and Numrich didn't have it. Closest I found was a screw on eBay for a Marlin 59/60 bolt action shotgun but looking at schematics on Numrich for both models, it looked like they both did the same thing. It worked.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top