RimfireCentral.com Forums - View Single Post - Barrel Wiggle Fix
View Single Post
  #2  
Old 06-12-2017, 09:53 PM
MarkB1
US Coast Guard Veteran NRA Member - Click Here To Join!

Join Date: 
May 2012
Location: 
Delaware
Posts: 
190
TPC Rating: 
0% (0)
Instead of using a shim like the felt paper for this rear wiggle, I filed down the two shoulder tabs at the base of the bolt stop. On my Hunter the two tabs were a little high and prevented the receiver from sitting solid on the frame. I just pushed the pin out just enough to remove the bolt stop and then filed down the shoulders. I re-blacked the bolt stop before I re-assembled the bolt stop.






Last edited by Sophia; 06-13-2017 at 11:52 AM.