RimfireCentral.com Forums - View Single Post - Model 69A-Factory Drilled and Tapped Barrel?
View Single Post
  #54  
Old 11-02-2010, 06:00 PM
JWA's Avatar
JWA

Join Date: 
Jan 2010
Location: 
32,000 ft+
Posts: 
5,239
TPC Rating: 
100% (4)
Yes, I am sure they probably did for the scope mounts. I know the roll-mark was also a standard set-up but I am not familiar with how accurate the roll-mark positioning would have been though. I never studied how accurately the roll-marks were applied so I think I will do some measurements on mine and see what kind of tolerances were maintained. If the roll-mark tolerances are tight enough that could very well be the best tip of the day in identifying properly positioned base holes.

Thanks!

Regards,
Reply With Quote